Home › Audio/Visual/Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Display Signal Circuit between Video Terminal and Television Display

for Preparation Click here


DESCRIPTION

This is the display signal from the video terminal to the television display assembly.

WIRING DIAGRAM


E145848E05


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO TERMINAL)


    E145847E04
  1. Disconnect the U2 television display assembly connector.

  1. Disconnect the S5 video terminal connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U2-24 (ADPG) - S5-8 (ADPG)
    Always
    Below 1 Ω
    U2-6 (VV+) - S5-5 (VV+)
    U2-22 (VV-) - S5-6 (VV-)
    U2-25 (SGN2) - S5-7 (SG)
    U2-24 (ADPG) - Body ground
    Always
    10 kΩ or higher
    U2-6 (VV+) - Body ground
    U2-22 (VV-) - Body ground
    U2-25 (SGN2) - Body ground

  1. Reconnect the television display assembly connector.

  1. Reconnect the video terminal connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT VIDEO TERMINAL


    E150834E02
  1. Using an oscilloscope, check the waveform.
    Reference 
    Terminal Connection
    S5-5 (VV+) - Body ground
    Tester Range
    0.2 V/DIV., 0.2 μsec./DIV.
    Vehicle Condition
    External device is playing, VTR is displayed

    OK:
    Waveform is as shown in the illustration.



NG
REPLACE VIDEO TERMINAL
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)