Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit is from the parking brake switch assembly to the navigation receiver assembly.

WIRING DIAGRAM


E138031E03


INSPECTION PROCEDURE

1.CHECK BRAKE WARNING SWITCH
  1. Check that the brake warning switch lights come on when the parking brake is applied and goes off when it is released.

    OK:
    The brake warning lights operate as specified above.



OK
Go to step 3
NG


2.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    E071372E01
  1. Disconnect the A5 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A5-1 - Switch body
    ON (When shaft is not pressed)
    Below 1 Ω
    OFF (When shaft is pressed)
    10 KΩ or higher

  1. Reconnect the parking brake switch assembly connector.



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - PARKING BRAKE SWITCH)


    E145836E02
  1. Disconnect the I6 navigation receiver assembly connector.

  1. Disconnect the A5 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I6-1 (PKB) - A5-1
    Always
    Below 1 Ω
    I6-1 (PKB) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the navigation receiver assembly connector.

  1. Reconnect the parking brake switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)