Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM

POWER BACK DOOR SYSTEM > Power Back Door cannot be Closed Using the Power Back Door Closer Switch

for Preparation Click here


DESCRIPTION

When the power back door cannot be closed using the power back door closer switch, one of the following may be malfunctioning: 1) power back door closer switch circuit, or 2) power back door drive unit (power back door ECU).

WIRING DIAGRAM


C179511E02


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Back Door / Data List /

  1. According to the display on the Techstream, read the Data List.

    Back Door 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PBD Close SW
    Power back door closer switch signal / ON or OFF
    ON: Power back door closer switch ON
    OFF: Power back door closer switch OFF
    -

    OK:
    The power back door closer switch functions as specified in the normal condition.



NG
Go to step 2
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)  

2.INSPECT POWER BACK DOOR CLOSER SWITCH


    B190837E01
  1. Remove the power back door closer switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Position
    Specified Condition
    5 - 8
    Pushed (ON)
    Below 1 Ω
    5 - 8
    Free (OFF)
    10 kΩ or higher

  1. Reinstall the power back door closer switch.



NG
REPLACE POWER BACK DOOR CLOSER SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (CLOSER SWITCH - DOOR DRIVE UNIT AND BODY GROUND)


    B190843E01
  1. Disconnect the O32 switch connector.

  1. Disconnect the O30 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O32-8 (DS1) - O30-4 (DS1)
    Always
    Below 1 Ω
    O32-5 (E) - Body ground
    Always
    Below 1 Ω
    O32-8 (DS1) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the switch connector.

  1. Reconnect the ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)