CURTAIN SHIELD AIRBAG CUTOFF SWITCH > INSPECTION |
| 1. INSPECT CURTAIN AIRBAG CUTOFF SWITCH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 4 (SW) - 1 (E) | Switch is not pressed | 10 kΩ or higher |
| 4 (SW) - 1 (E) | Switch is pressed | Below 1 Ω |
Check the illumination operation.
Connect the positive (+) lead from the battery to terminal 3 (ILL+) and the negative (-) lead to terminal 2 (ILL-), and then check that the illumination lights up.