Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH

POWER STEERING OIL PRESSURE SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING OIL PRESSURE SENSOR
  1. Install a new O-ring to the power steering oil pressure sensor.

  1. Apply a light coat of power steering fluid to the O-ring of the power steering oil pressure sensor.



    A185643
  1. Using a 24 mm deep socket wrench, install the power steering oil pressure sensor.

    Torque:
    21 N*m{ 210 kgf*cm , 16 ft.*lbf }

    NOTICE:
    1. Do not allow foreign matter to contact the oil seal face of the power steering oil pressure sensor (connecting surface with pressure feed tube).
    2. Be careful not to damage the O-ring when installing the power steering oil pressure sensor.

  1. Connect the power steering oil pressure sensor connector.



2. INSTALL AIR CLEANER HOSE ASSEMBLY


    A153488E02
  1. Install the air cleaner hose assembly with the 2 clamps.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

    HINT:
    Make sure that the clamp band end is aligned with the limit mark when the hose clamp is tightened, as indicated by A and B in the illustration.

  1. Connect the vacuum hose and No. 2 ventilation hose.



3. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY


    A153486
  1. Install the throttle body cover sub-assembly with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



4. ADD POWER STEERING FLUID


5. BLEED POWER STEERING FLUID
  1. Check the fluid level.

  1. Jack up the front of the vehicle and support it with stands.

  1. Turn the steering wheel.

    1. With the engine stopped, turn the wheel slowly from lock to lock several times.

  1. Lower the vehicle.

  1. Start the engine.

  1. Run the engine at idle for a few minutes.

  1. Turn the steering wheel.

    1. With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.(*1)

    2. Repeat (*1) several times.

  1. Stop the engine.



    C124274E02
  1. Check for foaming or emulsification.
    If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.

  1. Check the fluid level.



6. INSPECT FOR POWER STEERING FLUID LEAK