Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH

POWER STEERING OIL PRESSURE SWITCH > REMOVAL

for Preparation Click here



1. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY


    A153486
  1. Remove the 2 nuts and throttle body cover sub-assembly.



2. REMOVE AIR CLEANER HOSE ASSEMBLY


    A153487
  1. Disconnect the vacuum hose and No. 2 ventilation hose.

  1. Loosen the 2 hose clamps and remove the air cleaner hose assembly.



3. DRAIN POWER STEERING FLUID


4. REMOVE POWER STEERING OIL PRESSURE SENSOR


    A185643
  1. Disconnect the power steering oil pressure sensor connector.

  1. Using a 24 mm deep socket wrench, remove the power steering oil pressure sensor.

  1. Remove the O-ring.