RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT CIRCUIT OPENING RELAY (C/OPN) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
| 2. INSPECT INTEGRATION RELAY (IG2) |
Measure the resistance of the IG2 MAIN fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IG2 MAIN fuse | Always | Below 1 Ω |
![]() |
Measure the resistance of the ignition relay No. 2 (IG2) circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1B-8 | Battery voltage is not applied to terminals 1B-6 and 1B-7 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1B-6 and 1B-7 | Below 1 Ω |
| 3. INSPECT INTEGRATION RELAY (EFI) |
Measure the resistance of the EFI No. 1 fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| EFI No. 1 fuse | Always | Below 1 Ω |
![]() |
Measure the resistance of the EFI MAIN relay circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1B-4 | Battery voltage is not applied to terminals 1B-2 and 1B-3 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1B-2 and 1B-3 | Below 1 Ω |
| 4. INSPECT INTEGRATION RELAY (A/F) |
Measure the resistance of the A/F fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A/F fuse | Always | Below 1 Ω |
![]() |
Measure the resistance of the A/F sensor heater relay circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1A-4 | Battery voltage is not applied to terminals 1A-2 and 1A-3 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1A-2 and 1A-3 | Below 1 Ω |
| 5. INSPECT FUEL PUMP RELAY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |