Home › Power Source / Network · NETWORKING › CAN COMMUNICATION SYSTEM

DTC    U0230    Lost Communication with Rear Gate Module

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U0230
No communication from power back door ECU
  1. Power source circuit of power back door ECU
  2. Power back door ECU
  3. Power back door ECU branch wire or connector

HINT:
w/ Power back door system


WIRING DIAGRAM


E158725E02


INSPECTION PROCEDURE

1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NEXT


2.CHECK FOR OPEN IN CAN BUS WIRE (POWER BACK DOOR ECU BRANCH WIRE)


    E158726E01
  1. Disconnect the O30 power back door ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    O30-6 (CANP) - O30-5 (CANN)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE POWER BACK DOOR ECU BRANCH WIRE OR CONNECTOR (CANP, CANN)
OK


3.CHECK HARNESS AND CONNECTOR (POWER BACK DOOR ECU - BATTERY AND BODY GROUND)


    E158726E05
  1. Reconnect the cable to the negative (-) battery terminal.

  1. Disconnect the O30 power back door ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O30-11 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    O30-12 (B) - Body ground
    Always
    11 to 14 V
    O30-10 (ECUB) - Body ground
    Always
    11 to 14 V
    O30-8 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER BACK DOOR UNIT ASSEMBLY (Click here)