Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR WIPER MOTOR GROMMET


E139081E02
  1. Apply MP grease to the entire surface of the wiper motor grommet lip.

    HINT:
    Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.



    E162547E01
  1. Install the rear wiper motor grommet with the mark directed up.



2. INSTALL REAR WIPER MOTOR ASSEMBLY


    E161698
  1. Install the rear wiper motor with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector and clamp.



3. INSTALL REAR WIPER BLADE ASSEMBLY


    E058837E10
  1. Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).

  1. Clean the wiper pivot serrations with a wire brush.

  1. Operate the wiper, and then stop the windshield wiper motor in the automatic stop position.



    E162548E01
  1. Install the rear wiper arm into the position shown in the illustration with the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    NOTICE:
    Position the rear wiper arm on the linear wiper step before tightening the nut.

    HINT:
    Hold the arm hinge down by hand while tightening the nut.



4. INSTALL REAR WIPER ARM HEAD CAP


    E161700
  1. Engage the claw and install the rear wiper head cap.



5. INSTALL BACK DOOR SERVICE HOLE COVER


B190522
  1. Apply butyl tape to the door panel, then install a new back door service hole cover as shown in the illustration.

    HINT:
    1. There should be no wrinkles or folds after attaching the service hole cover.
    2. After attaching the service hole cover, check the quality of the seal.



6. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


B190520
  1. Engage the 11 clips and install the back door trim board assembly.



7. INSTALL BACK DOOR PULL STRAP


B190519
  1. Install the back door pull strap with the bolt.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



8. INSTALL BACK DOOR STRAP COVER


B195035
  1. Engage the claw and slid the back door strap cover as shown in the illustration, and install it.



9. INSTALL BACK DOOR SIDE GARNISH LH


B190516
  1. Engage the 3 clips and install the back door side garnish LH.



10. INSTALL BACK DOOR SIDE GARNISH RH


B190515
  1. Engage the 2 clips and install the back door side garnish RH.



11. INSTALL BACK DOOR CENTER GARNISH


B190514
  1. Engage the 4 clips and the claw and install the back door center garnish.



12. INSTALL POWER BACK DOOR ROD (w/ Power Back Door)


B194234
  1. Install the power back door rod with the 2 stop rings.