Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER ACTUATOR

HEADLIGHT CLEANER ACTUATOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both sides.
  2. The procedure described below is for the LH side.



1. REMOVE FRONT END PANEL


    B191650
  1. Remove the 2 clips.



    B191652
  1. Disengage the 2 claws and 2 clips and remove the front end panel.



2. REMOVE HEADLIGHT ASSEMBLY


    E142781
  1. Remove the 2 screws.

  1. Remove the bolt.

  1. Disconnect the connectors, and then remove the headlight.



3. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY


    E161331
  1. Remove the 3 screws and headlight washer actuator sub-assembly LH.