Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER SWITCH

HEADLIGHT CLEANER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEAD LIGHT CLEANER SWITCH ASSEMBLY


    E163904E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (L) - 8 (B)
    Pushed
    Below 1 Ω
    5 (L) - 8 (B)
    Free
    10 kΩ or higher

    If the result is not as specified, replace the head light cleaner switch.



    E163903E02
  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 7 (Ill+) and the negative (-) battery lead to terminal 6 (Ill-), and then check that the illumination illuminates.

      OK:
      Illumination illuminates.

      If the illumination does not illuminate, replace the head light cleaner switch.