FRONT ACCELERATION SENSOR > INSTALLATION |
| 1. INSTALL ACCELERATION SENSOR ASSEMBLY (for LH Side) |
![]() |
Install the acceleration sensor with the nut.
Connect the acceleration sensor connector.
| 2. INSTALL ACCELERATION SENSOR ASSEMBLY (for RH Side) |
![]() |
Install the acceleration sensor with the nut.
Connect the acceleration sensor connector.
| 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH |
![]() |
Engage the 4 claws and install the finish panel.
Install the 3 <D> screws and bolt <A>.
| 4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() |
Engage the 2 guides and 4 claws and install the under cover.
| 5. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT |
![]() |
Connect the connector and engage the clamp.
Engage the 2 claws to install the safety pad insert.
Install the 4 <A> bolts.
| 6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Engage the 2 claws and install the sensor.
Connect the connectors.
Engage the 4 clips and claw and install the finish panel.
Install the 2 <A> bolts.
| 7. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.
engage the 3 claws to install the hood lock lever
| 8. INSTALL INSTRUMENT SIDE PANEL LH |
![]() |
Engage the 4 guides and 3 claws and install the side panel.
| 9. INSTALL INSTRUMENT SIDE PANEL RH |
![]() |
Engage the 3 guides and 3 claws and install the side panel.
| 10. INSTALL COWL SIDE TRIM BOARD LH |
| 11. INSTALL COWL SIDE TRIM BOARD RH |
![]() |
Engage the 2 clips to install the cowl side trim board.
Install the clip.
| 12. INSTALL FRONT DOOR SCUFF PLATE LH |
| 13. INSTALL FRONT DOOR SCUFF PLATE RH |
![]() |
Engage the 9 claws to install the scuff plate.