Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR

FRONT ACCELERATION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE FRONT DOOR SCUFF PLATE RH


    B190151
  1. Detach the 9 claws and remove the scuff plate.



3. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



4. REMOVE COWL SIDE TRIM BOARD RH


    B190152
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board.



5. REMOVE INSTRUMENT SIDE PANEL LH


    B192331E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 claws and 4 guides and remove the side panel.



6. REMOVE INSTRUMENT SIDE PANEL RH


    B192338E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 claws and 3 guides and remove the side panel.



7. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Disengage the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B192333
  1. Remove the 2 <A> bolts.

  1. Disengage the 4 clips and claw.

  1. Disengage the 2 claws and separate the sensor.

  1. Disconnect the connectors and remove the finish panel.



9. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT


B192337
  1. Remove the 4 <A> bolts.

  1. Disengage the 2 claws.

  1. Disconnect the connector and clamp and remove the safety pad insert.



10. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B192340
  1. Disengage the 4 claws and 2 guides and remove the under cover.



11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


B192341
  1. Remove the bolt <A> and 3 <D> screws.

  1. Disengage the 4 claws and remove the finish panel.



12. REMOVE ACCELERATION SENSOR ASSEMBLY (for LH Side)


C180585
  1. Disconnect the acceleration sensor connector.

  1. Remove the nut and the acceleration sensor.



13. REMOVE ACCELERATION SENSOR ASSEMBLY (for RH Side)


C180586
  1. Disconnect the acceleration sensor connector.

  1. Remove the nut and the acceleration sensor.