Home › Suspension › SUSPENSION CONTROL › ABSORBER CONTROL ACTUATOR

ABSORBER CONTROL ACTUATOR > INSPECTION

for Preparation Click here



1. INSPECT ABSORBER CONTROL ACTUATOR


C179520E02
  1. Inspect the absorber control actuator LH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Sensor Condition
    Specified Condition
    1 (FAL+) - 2 (FAL-)
    Always
    6.4 to 7.2 Ω
    3 (FBL-) - 4 (FBL+)
    Always
    6.4 to 7.2 Ω



    C179520E01
  1. Inspect the absorber control actuator RH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Sensor Condition
    Specified Condition
    1 (FAR+) - 2 (FAR-)
    Always
    6.4 to 7.2 Ω
    3 (FBR-) - 4 (FBLR+)
    Always
    6.4 to 7.2 Ω