REAR STABILIZER BAR > INSTALLATION |
| 1. INSTALL REAR STABILIZER BUSH |
Install the 2 bushes to the outer side of the bush stoppers on the rear stabilizer bar.
| 2. TEMPORARILY INSTALL REAR STABILIZER BAR |
Temporarily install the rear stabilizer bar with the 4 bolts.
| 3. TIGHTEN REAR STABILIZER BRACKET |
![]() |
Install the rear stabilizer bar with the 4 bolts.
| 4. TEMPORARILY INSTALL REAR STABILIZER LINK ASSEMBLY LH |
![]() |
Temporarily install the rear stabilizer link with the 2 nuts.
| 5. TEMPORARILY INSTALL REAR STABILIZER LINK ASSEMBLY RH |
| 6. INSTALL PROPELLER SHAFT ASSEMBLY (for 2WD) |
| 7. INSTALL PROPELLER SHAFT ASSEMBLY (for 4WD) |
![]() |
Align the matchmarks on the propeller shaft flange and differential flange.
Align the matchmarks on the propeller shaft flange and transfer flange.
Install the propeller shaft assembly with the 8 nuts.
| 8. REMOVE TRANSFER HEAT INSULATOR (for 4WD) |
![]() |
Install the transfer heat insulator with the 3 bolts.
| 9. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) |
![]() |
Install the propeller shaft heat insulator with the 2 bolts.
| 10. INSTALL EXHAUST PIPE ASSEMBLY TAIL (for 3UR-FE) |
Connect the tailpipe to the exhaust pipe support.
![]() |
Install a new gasket to the center exhaust pipe.
Connect the tailpipe to the center exhaust pipe.
Attach a new clamp to the tailpipe and center exhaust pipe. Then install the bolt to the clamp.
| 11. INSTALL EXHAUST PIPE ASSEMBLY TAIL (for 2UZ-FE) |
![]() |
Install the new gasket to the center exhaust pipe assembly.
Connect the tail exhaust pipe assembly to the exhaust pipe support.
Install the tail exhaust pipe assembly with the new clamp.
| 12. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 13. TIGHTEN REAR STABILIZER LINK ASSEMBLY LH |
Install the rear stabilizer link with the 2 nuts.
| 14. TIGHTEN REAR STABILIZER LINK ASSEMBLY RH |