OIL COOLER > INSTALLATION |
| 1. INSTALL TRANSMISSION OIL COOLER ASSEMBLY (w/o Trailer Towing System) |
![]() |
Coat 2 new O-rings with ATF, and install them to the transmission oil cooler.
Align the transmission oil cooler with the transmission oil cooler spacer and assemble them with the 3 bolts.
Connect the 2 transmission oil cooler hoses to the transmission oil cooler spacer with the 2 clips.
![]() |
Temporarily install the transmission oil cooler with transmission oil cooler spacer with bolt A.
Install the bolt B and tighten it to the specified torque. Then tighten bolt A to the specified torque.
Connect the 2 transmission oil cooler hoses with the 2 clips.
| 2. INSTALL TRANSMISSION OIL COOLER ASSEMBLY (w/ Trailer Towing System) |
![]() |
Coat 2 new O-rings with ATF, and install them to the transmission oil cooler.
Align the transmission oil cooler with transmission oil thermostat and assemble them with the 3 bolts.
Connect the 2 transmission oil cooler hoses to the transmission oil thermostat with 2 clips.
![]() |
Temporarily install the transmission oil cooler with transmission oil thermostat with bolt A.
Install the bolt B and tighten it to the specified torque. Then tighten bolt A to the specified torque.
Connect the 2 transmission oil cooler hoses with the 2 clips.
![]() |
Connect the 2 No. 2 transmission oil cooler hoses to the transmission oil thermostat.
| 3. CONNECT WATER BY-PASS PIPE ASSEMBLY |
![]() |
Connect the 2 water by-pass hoses with the 2 clips and install the water by-pass pipe with the bolt.
| 4. INSTALL HOSE HEAT PROTECTOR |
![]() |
Install the hose heat protector with the bolt.
| 5. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Install the new gasket to the front exhaust pipe assembly.
Install the front exhaust pipe assembly with the 3 new nuts.
![]() |
Connect the heated oxygen sensor connector.
![]() |
Connect the air fuel ratio sensor connector.
| 6. ADD ENGINE COOLANT |
Add engine coolant.
![]() |
Slowly pour coolant into the radiator reservoir until it reaches the FULL line.
Install the reservoir cap.
Press the inlet and outlet radiator hoses several times by hand, and then check the coolant level. If the coolant level is low, add coolant.
Install the radiator cap.
Start the engine and warm it up until the thermostat opens.
Maintain the engine speed at 2000 to 2500 rpm and warm up the engine until the cooling fan operates.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine, and wait until the engine coolant cools down.
![]() |
If the coolant level is below the LOW line, repeat all of the procedures above.
| 7. ADJUST AUTOMATIC TRANSMISSION FLUID |
Adjust automatic transmission fluid (Click here).
| 8. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK |
| 9. INSPECT FOR ENGINE COOLANT LEAK |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop. If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.
| 10. INSPECT FOR EXHAUST GAS LEAK |