Home › Drivetrain ยท A750E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL COOLER

OIL COOLER > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }



    A156211E01

  1. Tighten the radiator drain cock plug by hand.



2. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A185584
  1. Disconnect the air fuel ratio sensor connector.



    A185585
  1. Disconnect the heated oxygen sensor connector and 2 clamps.



    A185586
  1. Remove the 3 nuts and remove the front exhaust pipe assembly.

  1. Remove the gasket form the front exhaust pipe assembly.



3. REMOVE HOSE HEAT PROTECTOR


    C161816
  1. Remove the bolt and hose heat protector.



4. DISCONNECT WATER BY-PASS PIPE ASSEMBLY


    C158371
  1. Remove the bolt and disconnect the 2 water by-pass hoses from the transmission oil cooler, and separate the water by-pass pipe assembly.

    HINT:
    Use a container to catch any coolant which flows out of the water by-pass hoses.



5. REMOVE TRANSMISSION OIL COOLER ASSEMBLY (w/o Trailer Towing System)


    C161814
  1. Disconnect the 2 transmission oil cooler hoses.

  1. Remove the 2 bolts and transmission oil cooler with transmission oil cooler spacer.



    C157012E03
  1. Remove the 3 bolts and separate the transmission oil cooler from the transmission oil cooler spacer.

  1. Remove the 2 O-rings.



6. REMOVE TRANSMISSION OIL COOLER ASSEMBLY (w/ Trailer Towing System)


    C155914
  1. Disconnect the 2 No. 2 transmission oil cooler hoses from the transmission oil thermostat.



    C179290
  1. Disconnect the 2 transmission oil cooler hoses.

  1. Remove the 2 bolts and transmission oil cooler with transmission oil thermostat.



    C179291E01
  1. Remove the 3 bolts and separate the oil cooler from the transmission oil thermostat.

  1. Remove the 2 O-rings.