Home › Drivetrain ยท AB60F AUTOMATIC TRANSMISSION / TRANSAXLE › OIL COOLER

OIL COOLER > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant from the radiator.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    A151835E01

  1. Tighten the radiator drain cock plug by hand.



2. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.



    A184929
  1. Remove the 3 nuts, front exhaust pipe and gasket from the exhaust manifold RH.



3. DISCONNECT WATER BY-PASS PIPE ASSEMBLY


    C162563
  1. Remove the bolt and disconnect the 2 water by-pass hoses from the transmission oil cooler. Then separate the by-pass pipe from the automatic transmission.

    HINT:
    Use a container to catch any coolant which flows out of the water by-pass hoses.



4. REMOVE TRANSMISSION OIL COOLER ASSEMBLY (w/o Trailer Towing System)


    C161367
  1. Remove the 3 bolts and transmission oil cooler with transmission oil cooler spacer.

  1. Separate the transmission oil cooler from the transmission oil cooler spacer.

  1. Remove the 4 O-rings.



5. REMOVE TRANSMISSION OIL COOLER ASSEMBLY (w/ Trailer Towing System)


    C162139
  1. Disconnect the 2 No. 2 transmission oil cooler hoses from the transmission oil thermostat.



    C161366
  1. Remove the 3 bolts and transmission oil cooler with transmission oil thermostat.

  1. Separate the transmission oil cooler from the transmission oil thermostat.

  1. Remove the 4 O-rings.