Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU

POWER STEERING ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



3. REMOVE INSTRUMENT SIDE PANEL LH


    B192331E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 claws and 4 guides and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B192333
  1. Remove the 2 <A> bolts.

  1. Disengage the 4 clips and claw.

  1. Disengage the 2 claws and separate the sensor.

  1. Disconnect the connectors and remove the finish panel.



5. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT


B192337
  1. Remove the 4 <A> bolts.

  1. Disengage the 2 claws.

  1. Disconnect the connector and clamp and remove the safety pad insert.



6. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B192334
  1. Disengage the 4 claws and separate the instrument panel finish panel retainer.



    B192335
  1. Disconnect the 2 connectors and clamp.

  1. Disengage the 12 clips and remove the finish panel.



7. REMOVE POWER STEERING ECU ASSEMBLY


C181335
  1. Disconnect the power steering ECU connector.

  1. Remove the nut and power steering ECU assembly.