Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR TOUCH SENSOR (for RH Side)

POWER BACK DOOR TOUCH SENSOR (for RH Side) > INSTALLATION

for Preparation Click here



1. INSTALL POWER BACK DOOR SENSOR RH


    B192122
  1. Install the power back door sensor with 2 clips.

  1. Install the 6 screws.

  1. Connect the connector.



2. INSTALL BACK DOOR NO. 2 SERVICE HOLE COVER


B190525
  1. Engage the 2 clips and install the back door No. 2 service hole cover with the 3 screws.



3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


B190520
  1. Engage the 11 clips and install the back door trim board assembly.



4. INSTALL BACK DOOR PULL STRAP


B190519
  1. Install the back door pull strap with the bolt.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



5. INSTALL BACK DOOR STRAP COVER


B195035
  1. Engage the claw and slid the back door strap cover as shown in the illustration, and install it.



6. INSTALL BACK DOOR SIDE GARNISH LH


B190516
  1. Engage the 3 clips and install the back door side garnish LH.



7. INSTALL BACK DOOR SIDE GARNISH RH


B190515
  1. Engage the 2 clips and install the back door side garnish RH.



8. INSTALL BACK DOOR CENTER GARNISH


B190514
  1. Engage the 4 clips and the claw and install the back door center garnish.



9. INSTALL POWER BACK DOOR ROD


B194234
  1. Install the power back door rod with the 2 stop rings.