POWER BACK DOOR TOUCH SENSOR (for RH Side) > REMOVAL |
| 1. REMOVE POWER BACK DOOR ROD |
![]() |
Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and power back door rod.
| 2. REMOVE BACK DOOR CENTER GARNISH |
![]() |
Disengage the 4 clips and the claw and remove the back door center garnish.
| 3. REMOVE BACK DOOR SIDE GARNISH RH |
![]() |
Disengage the 2 clips and remove the back door side garnish RH.
| 4. REMOVE BACK DOOR SIDE GARNISH LH |
![]() |
Disengage the 3 clips and remove the back door side garnish LH
| 5. REMOVE BACK DOOR STRAP COVER |
![]() |
Slide the back door strap cover and disengage the claw and remove the back door strap cover.
| 6. REMOVE BACK DOOR PULL STRAP |
![]() |
Remove the bolt and remove the back door pull strap.
| 7. REMOVE BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Disengage the 11 clips and remove the back door trim board assembly.
| 8. REMOVE BACK DOOR NO. 2 SERVICE HOLE COVER |
![]() |
Remove the 3 screws and disengage the 2 clips and remove the back door No. 2 service hole cover.
| 9. REMOVE POWER BACK DOOR SENSOR RH |
Disconnect the connector.
![]() |
Remove the 6 screws.
Disengage the 2 clips and remove the power back door sensor.