ACCESSORY SOCKET SYSTEM > TERMINALS OF ECU |
| CHECK POWER SOURCE CONTROL ECU |

Disconnect the H53 power source control ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| H53-2 (VAC) - Body ground | GR - Body ground | ACC signal input | Ignition switch off → ACC | Below 1 V → 11 to 14V |
| H53-5 (+B) - Body ground | G - Body ground | Battery power supply | Always | 11 to 14 V |
| H53-7 (GND) - Body ground | W-B - Body ground | Body ground | Always | Below 1 Ω |
| H53-9 (VIG) - Body ground | P - Body ground | IG signal input | Ignition switch off → ON | Below 1 V → 11 to 14V |
Reconnect the H53 power source control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| H53-1 (RLC) - Body ground | Y - Body ground | Power outlet relay control signal | Ignition switch off → ACC or ON | 11 to 14 V → Below 1 V |
| Ignition switch ON → ACC or off (approximately 2 hours elapsed) | Below 1 V → 11 to 14V | |||
| H53-4 (OUT1) - Body ground | R - Body ground | Power outlet operate signal | Ignition switch off → ACC or ON | Below 1 V → 11 to 14V |
| Ignition switch ON → ACC or off (approximately 2 hours elapsed) | 11 to 14 V → Below 1 V | |||
| H53-10 (+B1) - Body ground | V - Body ground | Power outlet relay operate signal | Ignition switch off → ACC or ON | Below 1 V → 11 to 14V |
| Ignition switch ON → ACC or off (approximately 2 hours elapsed) | 11 to 14 V → Below 1 V |