Home › Engine / Hybrid System · 2UZ-FE › STARTING › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STARTER RELAY


    B060778E26
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Terminal Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



2. INSPECT MAIN BODY ECU (ACC RELAY)



A160907E01

  1. Measure the resistance of the ACC relay circuit.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      DD47 - DD8
      Battery voltage is not applied to terminals DD45 and DD62
      10 kΩ or higher
      Battery voltage is applied to terminals DD45 and DD62
      Below 1 Ω

      If the result is not as specified, replace the main body ECU.



3. INSPECT ACC CUT RELAY


    A087121E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage is not applied to terminals 1 and 2
    Below 1 Ω
    Battery voltage is applied to terminals 1 and 2
    10 kΩ or higher

    If the result is not as specified, replace the relay.