Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU

CLEARANCE WARNING ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH


    B190151
  1. Detach the 9 claws and remove the scuff plate.



2. REMOVE COWL SIDE TRIM BOARD RH


    B190152
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board.



3. REMOVE INSTRUMENT SIDE PANEL RH


    B192338E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 claws and 3 guides and remove the side panel.



4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B192340
  1. Disengage the 4 claws and 2 guides and remove the under cover.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


B192341
  1. Remove the bolt <A> and 3 <D> screws.

  1. Disengage the 4 claws and remove the finish panel.



6. REMOVE NO. 1 ECU INTEGRATION BRACKET


    E161796
  1. Disconnect the 3 connectors and harness clamp.

  1. Remove the bolt, nut and the No. 1 ECU integration bracket.



7. REMOVE CLEARANCE WARNING ECU ASSEMBLY


    E161797
  1. Remove the 2 nuts and clearance warning ECU.