Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT SWITCH

ROOM LIGHT SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side .



3. REMOVE INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side .



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B192333
  1. Remove the 2 <A> bolts.

  1. Disengage the 4 clips and claw.

  1. Disengage the 2 claws and separate the sensor.

  1. Disconnect the connectors and remove the finish panel.



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B192334
  1. Disengage the 4 claws and separate the instrument panel finish panel retainer.



    B192335
  1. Disconnect the 2 connectors and clamp.

  1. Disengage the 12 clips and remove the finish panel.



6. REMOVE INTERIOR DOME LIGHT SWITCH ASSEMBLY


    E161810
  1. Disengage the 2 claws and remove the interior dome light switch.