Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY


    B192566E01
  1. Push the upper part of the mirror surface and tilt it.

  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, push the bottom of the glass upwards as shown in the illustration. Slide the glass upwards to detach the 4 claws, and remove the outer rear view mirror glass.

  1. Disconnect the connectors.