Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY

REAR LIGHT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR LIGHT ASSEMBLY LH


    E161855E01
  1. Disconnect the connector from the rear light.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    V8-1 - V8-3
    Light control switch OFF
    Below 1 Ω
    Light control switch in TAIL
    11 to 14 V
    V8-4 - V8-3
    Shift lever not in R
    Below 1 Ω
    Shift lever in R
    11 to 14 V



2. INSPECT REAR LIGHT ASSEMBLY RH


    E161855E02
  1. Disconnect the connector from the rear light.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    V7-1 - V7-3
    Light control switch OFF
    Below 1 Ω
    Light control switch in TAIL
    11 to 14 V
    V7-2 - V7-3
    Shift lever not in R
    Below 1 Ω
    Shift lever in R
    11 to 14 V