LICENSE PLATE LIGHT ASSEMBLY > INSTALLATION |
| 1. INSTALL LICENSE PLATE LIGHT BULB |
Install the license plate light bulb into the light socket.
| 2. INSTALL LICENSE PLATE LIGHT ASSEMBLY |
![]() |
Tighten the 4 screws.
Connect the 4 harness clamps and install the license plate light.
| 3. INSTALL REAR TELEVISION CAMERA ASSEMBLY |
![]() |
Engage the 2 claws and install the rear television camera.
![]() |
Tighten the 2 nuts.
Connect the connector.
| 4. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY |
![]() |
Engage the 2 clips and install the back door outside garnish.
![]() |
Tighten the 4 nuts.
Connect the connector.
| 5. INSTALL BACK DOOR SERVICE HOLE COVER |
![]() |
Apply butyl tape to the door panel, then install a new back door service hole cover as shown in the illustration.
| 6. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Engage the 11 clips and install the back door trim board assembly.
| 7. INSTALL BACK DOOR PULL STRAP |
![]() |
Install the back door pull strap with the bolt.
| 8. INSTALL BACK DOOR STRAP COVER |
![]() |
Engage the claw and slid the back door strap cover as shown in the illustration, and install it.
| 9. INSTALL BACK DOOR SIDE GARNISH LH |
![]() |
Engage the 3 clips and install the back door side garnish LH.
| 10. INSTALL BACK DOOR SIDE GARNISH RH |
![]() |
Engage the 2 clips and install the back door side garnish RH.
| 11. INSTALL BACK DOOR CENTER GARNISH |
![]() |
Engage the 4 clips and the claw and install the back door center garnish.