Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > INSTALLATION

for Preparation Click here



1. INSTALL REAR BUMPER COVER


B191656
  1. Engage the 12 claws and install the rear bumper cover.



    B195443
  1. Engage the 2 harness clamps and connect the connector.



    B191655
  1. Tighten the 6 bolts for upper side of the rear bumper cover.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Tighten the 2 bolts for lower side of the rear bumper cover.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Tighten the 2 screws and install the 2 clips.



2. INSTALL REAR QUARTER PANEL MUDGUARD LH


B191653
  1. Install the rear quarter panel mudguard with the 9 screws and clip.



3. INSTALL REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure as for the LH side.