Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > INSTALLATION

for Preparation Click here



1. INSTALL REAR DOOR GLASS OUTER WEATHERSTRIP


B191705
  1. Engage the 5 claws and clip and install a new rear door glass outer weatherstrip.



2. INSTALL REAR DOOR WINDOW FRAME REAR MOULDING
  1. Apply Primer G to the installation part of rear door window frame rear moulding.

    NOTICE:
    1. Allow the primer to dry for 3 minutes or more.
    2. Throw away any leftover Primer G.
    3. Do not apply too much Primer G.

  1. Remove the release paper from the rear door window frame rear moulding.



    B191717
  1. Engage the claw and clip and install the rear door window frame rear moulding.