Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure described below is for the LH side.



1. REMOVE REAR DOOR WINDOW FRAME REAR MOULDING


B191717
  1. Disengage the claw and clip and remove the rear door window frame rear moulding.

    NOTICE:
    Remove any tape remaining on the door panel side.



2. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP


B191703E01
  1. Apply protective tape to the door panel in the area around the rear door glass outer weatherstrip.



    B191704E01
  1. Using a moulding remover, disengage the 5 claws and the clip and remove the rear door glass outer weatherstrip.