Home › Vehicle Interior › SEAT BELT › REAR NO. 2 SEAT OUTER BELT ASSEMBLY

REAR NO. 2 SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the RH side.



1. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
  1. Remove the curtain shield airbag assembly (Click here).



2. REMOVE POWER BACK DOOR ROD (w/ Power Back Door)


    B194506E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and power back door rod.



3. REMOVE POWER BACK DOOR UNIT ASSEMBLY (w/ Power Back Door)


    B192141
  1. Disconnect the connector.

  1. Remove the 4 bolts and remove the power back door unit.



4. REMOVE QUARTER TRIM BRACKET RH (for RH Side)


    I104301
  1. Disengage the clamp.

  1. Remove the 2 bolts and the quarter trim bracket.



5. REMOVE COVER SUB-ASSEMBLY (for RH Side)


    I104302
  1. Disengage the 2 claws and remove the cover.



6. REMOVE REAR SIDE NO. 1 AIR DUCT (for RH Side)


    I104303
  1. Disengage the clamps.

  1. Remove the clip and the air duct.



7. REMOVE QUARTER SIDE SPEAKER ASSEMBLY (for RH Side)


    E161055
  1. Disconnect the connector.

  1. Disengage the guide.

  1. Remove the 2 bolts and the quarter side speaker RH.



8. REMOVE REAR SEAT SHOULDER BELT GUIDE


    B194790
  1. Remove the 2 bolts and rear seat shoulder belt guide.



9. REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY RH


    B194791
  1. Remove the nut and shoulder anchor.



    B194792
  1. Remove the 2 bolts and rear No. 2 seat outer belt assembly.



10. REMOVE REAR ROOF NO. 1 AIR DUCT (for RH Side)


    B194793
  1. Remove the 3 clips and rear roof No. 1 air duct.



11. REMOVE REAR SEAT OUTER BELT ANCHOR BRACKET ASSEMBLY RH


    B194794
  1. Remove the 2 bolts and rear seat outer belt anchor bracket assembly.