REAR CENTER SEAT OUTER BELT ASSEMBLY (for Rear No. 1 Seat) > REMOVAL |
| 1. REMOVE REAR CENTER SEAT ASSEMBLY |
Remove the rear center seat assembly (Click here).
| 2. REMOVE REAR SEAT CUSHION HINGE COVER UPPER LH |
![]() |
Disengage the hook.
Remove the screw.
Disengage the 2 claws and remove the rear seat cushion hinge cover.
| 3. REMOVE REAR SEAT CUSHION HINGE COVER UPPER RH |
![]() |
Disengage the hook.
Remove the screw.
Disengage the 2 claws and remove the rear seat cushion hinge cover.
| 4. REMOVE CENTER SEAT CUSHION ASSEMBLY |
![]() |
Disengage the hook and loop fastener and hook.
![]() |
Remove the 2 bolts.
Using a T45 "TORX" socket, remove the 2 bolts and 2 bushes. Then remove the center seat cushion assembly.
| 5. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY |
| 6. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY |
![]() |
Disengage the 6 clips and remove the rear seatback board sub-assembly.
| 7. REMOVE CENTER SEAT HINGE COVER LH |
![]() |
Remove the screw.
Disengage the 3 claws and clip and remove the center seat hinge cover.
| 8. REMOVE CENTER SEAT HINGE COVER RH |
![]() |
Remove the screw.
Disengage the 3 claws and clip and remove the center seat hinge cover.
| 9. REMOVE REAR SEAT CUSHION UNDER COVER |
![]() |
Remove the 2 screws and rear seat cushion under cover.
| 10. REMOVE REAR SEAT SHOULDER BELT HOLE COVER NO. 1 |
![]() |
Disengage the 4 claws and remove the rear seat shoulder hole cover No. 1.
| 11. REMOVE REAR SEATBACK LOCK BEZEL UPPER |
![]() |
Remove the center seat outer belt lower bolt.
![]() |
Remove the 2 screws and rear seatback lock bezel upper.
| 12. REMOVE REAR SEAT SHOULDER BELT HOLE COVER NO. 2 |
![]() |
Using a T30 "TORX" socket, remove the 2 bolts and rear seat shoulder belt hole cover No. 2.
| 13. REMOVE REAR SEATBACK LOCK STRIKER COVER |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and guide and remove the rear seatback lock striker cover.
| 14. REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH |
![]() |
Remove the 2 screws.
Disconnect the cable and remove the rear seat lock control lever sub-assembly.
| 15. REMOVE REAR SEAT HEADREST SUPPORT |
![]() |
Disengage the 4 claws and remove the 2 rear seat headrest supports.
| 16. REMOVE REAR SEAT SHOULDER BELT HOLE COVER NO. 3 |
![]() |
Remove the 2 screws.
Disengage the 2 claws and remove the rear seat shoulder belt hole cover No. 3.
| 17. REMOVE ARMREST ASSEMBLY |
![]() |
Remove the 2 nuts and armrest assembly.
| 18. REMOVE SEATBACK COVER WITH PAD |
![]() |
Remove the 5 hog rings.
![]() |
Remove the 6 hog rings.
![]() |
Disengage the hooks.
![]() |
Disengage the hooks and remove the seatback cover with pad.
| 19. REMOVE CENTER SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the cable tie.
Remove the 4 nuts and center seat outer belt assembly.