Home › Engine / Hybrid System ยท 3UR-FBE › FUEL › FUEL PRESSURE PULSATION DAMPER

FUEL PRESSURE PULSATION DAMPER > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
  1. Discharge the fuel system pressure (Click here).



2. REMOVE V-BANK COVER


A165576E03
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



3. REMOVE AIR CLEANER HOSE ASSEMBLY


A187008
  1. Disconnect the vacuum hose and ventilation hose.

  1. Loosen the 2 clamps.

  1. Remove the air cleaner hose.



4. DISCONNECT NO. 3 VENTILATION HOSE


    A198623
  1. Disconnect the No. 3 ventilation hose and No. 6 wire harness connector.



5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


A191557
  1. Remove the No. 1 engine cover sub-assembly.



6. REMOVE NO. 3 ENGINE COVER


A191558
  1. Remove the No. 3 engine cover.



7. REMOVE FUEL PRESSURE PULSATION DAMPER CAP


    A194638
  1. Remove the 2 fuel pressure pulsation damper caps.



8. REMOVE FUEL PRESSURE PULSATION DAMPER COVER


    A194639
  1. Remove the 4 bolts and 2 fuel pressure pulsation damper covers.



9. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    A194640
  1. Pull the 2 fuel pressure pulsation dampers out of the fuel delivery pipes to remove them.