REAR DIFFERENTIAL CARRIER OIL SEAL > REPLACEMENT > Preparation
|  |
|
SST

| 09223-56010
| Crankshaft Rear Oil Seal Replacer
| 
| 09308-10010
| Oil Seal Puller
| 
| 09316-60011
| Transmission & Transfer Bearing Replacer
| 
| (09316-00011)
| Replacer Pipe
| 
| 09330-00021
| Companion Flange Holding Tool
| 
| 09506-30012
| Differential Drive Pinion Rear Bearing Cone Replacer
| 
| 09527-17011
| Rear Axle Shaft Bearing Remover
| 
| 09930-00010
| Drive Shaft Nut Chisel
| 
| 09950-30012
| Puller A Set
| 
| (09951-03010)
| Upper Plate
| 
| (09953-03010)
| Center Bolt
| 
| (09954-03010)
| Arm
| 
| 09950-40011
| Puller B Set
| 
| (09951-04010)
| Hanger 150
| 
| (09952-04010)
| Slide Arm
| 
| (09953-04020)
| Center Bolt 150
| 
| (09954-04010)
| Arm 25
| 
| 09955-03050
| Lower Plate 150 No.2
| 
| 09955-04110
| Claw No.11
| 
| 09958-04020
| Holder No.2
| |
|
EQUIPMENTChisel
| -
| Dial indicator with magnetic base
| -
| Micrometer
| -
| Press
| -
| Prussian blue
| -
| Tape
| -
| Torque wrench
| -
| |
|
LUBRICANT / Front differentialCapacity
| Oil type and viscosity
| 2.05 to 2.15 liters (2.2 to 2.3 US qts., 1.8 to 1.9 Imp. qts.)
| Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent
|
LUBRICANT / Rear differential (1GR-FE, 2UZ-FE)Wheel base type
| Cab type
| Drive type
| Capacity
| Oil type and viscosity
| 3220 mm (10 ft. 6.8 in.)
| Regular
| 2WD
| 4.00 to 4.10 liters (4.2 to 4.3 US qts., 3.5 to 3.6 Imp. qts.)
| Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent
| 4WD
| 3700 mm (12 ft. 1.7 in.)
| ALL
| 2WD
| 4.55 to 4.65 liters (4.8 to 4.9 US qts., 4.0 to 4.1 Imp. qts.)
| 4WD
| 4180 mm (13 ft. 8.6 in.)
| 2WD
| 4WD
|
LUBRICANT / Rear differential (3UR-FE)Wheel base type
| Cab type
| Drive type
| Capacity
| Oil type and viscosity
| 3220 mm (10 ft. 6.8 in.)
| Regular
| 2WD
| 3.40 to 3.50 liters (3.6 to 3.7 US qts., 3.0 to 3.1 Imp. qts.)
| Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent
| 4WD
| 3700 mm (12 ft. 1.7 in.)
| Regular
| 2WD
| 3.55 to 3.65 liters (3.8 to 3.9 US qts., 3.1 to 3.2 Imp. qts.)
| 4WD
| Double
| 2WD
| 4WD
| CrewMax
| 2WD
| 3.70 to 3.80 liters (3.9 to 4.0 US qts., 3.2 to 3.3 Imp. qts.)
| 4WD
| 3.55 to 3.65 liters (3.8 to 3.9 US qts., 3.1 to 3.2 Imp. qts.)
| 4180 mm (13 ft. 8.6 in.)
| Double
| 2WD
| 3.70 to 3.80 liters (3.9 to 4.0 US qts., 3.2 to 3.3 Imp. qts.)
| 4WD
| |
|
RECOMMENDED TOOLS
| 09011-2C590
| Socket Wrench 30mm/12p
|
| 
| 09051-1C110
| Plastic Hammer 420g
|
| 
| 09051-1C410
| Pin Punch 5
|
| 
| 09905-00012
| Snap Ring No. 1 Expander
|
| 
| 09905-00013
| Snap Ring Pliers
|
| |
|
SSMToyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent
| -
| Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
| -
| Toyota Genuine Adhesive 1360K, Three Bond 1360K or equivalent
| -
| |
|