DTC P0630 VIN not Programmed or Mismatch - ECM / PCM |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0630 | When either condition below is met: (1 trip detection logic)
| ECM |
| Related DTCs | P0630: VIN not programmed |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 0.325 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| VIN code | Not programmed |
| VIN code | Programmed |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ CURRENT DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| DTC P0630 is output | A |
| DTC P0630 and other are output | B |
|
| ||||
| A | |
| 2.INPUT VIN WITH TECHSTREAM |
Refer to Registration (Click here).
| NEXT | ||
| ||