Home › Engine / Hybrid System · 1UR-FE › ENGINE CONTROL › MANIFOLD ABSOLUTE PRESSURE SENSOR

MANIFOLD ABSOLUTE PRESSURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR


A106949E02
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (THA) - 2 (E2)
      -20°C (-4°F)
      14.6 to 17.8 kΩ
      4 (THA) - 2 (E2)
      20°C (68°F)
      2.21 to 2.69 kΩ
      4 (THA) - 2 (E2)
      80°C (176°F)
      0.29 to 0.354 kΩ

      If the result is not as specified, replace the manifold absolute pressure sensor.