Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B161741
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B161742
  1. Detach the 12 clips and remove the console panel.



3. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B222976
  1. Move the shift lever to N.

  1. Remove the clip.

  1. Detach the 6 clips and remove the console panel.

  1. Disconnect the connector



4. REMOVE REAR CONSOLE BOX POCKET


B188221
  1. Remove the rear console box pocket.



5. REMOVE CONSOLE BOX CARPET


B188222
  1. Remove the console box carpet.



6. REMOVE REAR CONSOLE BOX ASSEMBLY


B188223
  1. Disconnect the connectors.



    B192330
  1. Remove the 4 bolts and 2 screws.

  1. Detach the 6 claws and remove the rear console box.



7. REMOVE YAW RATE SENSOR
  1. Remove the 2 nuts (labeled A) and sensor.



  1. Disconnect the sensor connector (labeled B), and then detach the clamp (labeled C) from the sensor bracket.


    C154452E01