Vehicle Condition
| Auto Cancel Condition
| Re-operation Condition
|
CRUISE main indicator light blinks
| - There is open or short in stop light switch circuit
- There is problem with vehicle speed signal
| Turn cruise control main switch on again
|
CRUISE main indicator light blinks
| - There is problem with input circuit of stop light switch circuit
- There is problem with cancel circuit
| Turn ignition switch off then on again
|
Cruise control is cancelled (The indicator light remains on)
| At the following conditions, the stored vehicle speed is maintained.
- Vehicle speed is lower than low speed limit (approx. 40 km/h (25 mph)) while running with cruise control on
- VSC operates
| Push cruise control main switch to + (ACCEL)/RES (RESUME)
|
Vehicle speed is lower than stored speed by approx. 16 km/h (10 mph) or more
| Push cruise control main switch to - (COAST)/SET
|
Cruise control is cancelled (The indicator light is off)
| There is a problem with throttle position sensor and motor
| Turn ignition switch off then on again
|