DTC P2610 ECM / PCM Internal Engine Off Timer Performance |
| DTC | Monitoring Item | Malfunction Detection Condition | Trouble Area | Detection Timing | Detection Logic |
| P2610 | Soak timer (built into ECM) | ECM internal malfunction | ECM | Engine running | 2 trip |

| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| Duration | 10 minutes: Timer malfunction Within 9.5 hours: Timer start-up malfunction |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTC not present | None |
| Ignition switch | ON |
| Engine | Running |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Monitor runs whenever following DTC not present | None |
| Elapsed time from engine stop | Less than 1800 seconds |
| Ignition switch | ON |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Monitor runs whenever following DTC not present | None |
| Elapsed time from engine stop | 2400 seconds or more |
| Ignition switch | ON |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Soak timer measurement when ECM CPU clock counts 10 minutes | Less than 7 minutes, or more than 13 minutes |
| ECM has a record of being started by soak timer | Yes |
| ECM has a record of being started by soak timer | No |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2.CHECK WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTCs (Click here).
Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
If no pending DTC is displayed, the repair has been successfully completed.
| NEXT | ||
| ||