FRONT SEAT OUTER BELT ASSEMBLY > DISPOSAL |

| 1. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY LH |
![]() |
Check if SST is functioning properly.
![]() |
Connect SST's red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
![]() |
Press SST activation switch and check that the LED in SST activation switch illuminates.
Disconnect SST from the battery.
Disconnect the pretensioner connector.
Disconnect the cable from the negative (-) battery terminal.
Remove the front door scuff plate .
Remove the rear door scuff plate .
Remove the front door opening trim weatherstrip .
Remove the rear door opening trim weatherstrip .
Remove the lower center pillar garnish .
![]() |
Disconnect the pretensioner connector as shown in the illustration.
Prepare SST for activation of the seat belt pretensioner.
Install the floor anchor of the seat belt.
![]() |
Connect SST (A) to SST (B). Then connect SST (B)'s connector to the seat belt pretensioner.
![]() |
Move SST at least 10 m (32.8 ft.) away from the front of the vehicle.
Close all the doors and windows of the vehicle.
Connect SST's red clip to the battery positive (+) terminal and the black clip to the negative (-) terminal.
Activate the seat belt pretensioner.
Confirm that no one is inside the vehicle or within 10 m (32.8 ft.) of the vehicle.
Press SST activation switch to activate the seat belt pretensioner.
Dispose of the front seat outer belt (with the seat belt pretensioner).