Home › Drivetrain ยท A760E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Refer to the How To Troubleshoot ECU Controlled System in Introduction section (Click here).


    NEXT


    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    4.CONNECT TECHSTREAM TO DLC3*

      NEXT


      5.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
      1. Refer to DTC Check/Clear (Click here).


      NEXT


      6.VISUAL INSPECTION

        NEXT


        7.SETTING CHECK MODE DIAGNOSIS*
        1. Refer to the Check Mode Procedure (Click here).


        NEXT


        8.PROBLEM SYMPTOM CONFIRMATION
        1. Refer to the Road Test (Click here).
          Result 
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B



        B.
        GO TO STEP 10
        A


        9.SYMPTOM SIMULATION
        1. Refer to the Electronic Circuit Inspection Procedure (Click here).


        NEXT


        10.DTC CHECK*
        1. Refer to DTC Check/Clear (Click here).
          Result 
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B



        B.
        GO TO STEP 18
        A


        11.BASIC INSPECTION
        1. Refer to Automatic Transmission Fluid (Click here).

        2. Refer to Park/Neutral Position Switch (Click here).

        3. Refer to Shift Lever Assembly (Click here).



        NG.
        GO TO STEP 21
        OK


        12.MECHANICAL SYSTEM TESTS
        1. Refer to the Mechanical System Tests (Click here).



        NG.
        GO TO STEP 17
        OK


        13.HYDRAULIC TEST
        1. Refer to the Hydraulic Test (Click here).



        NG.
        GO TO STEP 17
        OK


        14.MANUAL SHIFTING TEST
        1. Refer to the Manual Shifting Test (Click here).



        NG.
        GO TO STEP 16
        OK


        15.PROBLEM SYMPTOMS TABLE CHAPTER 1
        1. Refer to the Problem Symptoms Table (Click here).



        NG.
        GO TO STEP 19
        OK


        16.PROBLEM SYMPTOMS TABLE CHAPTER 2
        1. Refer to the Problem Symptoms Table (Click here).


        NEXT


        17.PART INSPECTION


          NG.
          GO TO STEP 21
          OK


          18.DTC CHART
          1. Refer to the Diagnostic Trouble Code Chart (Click here).


          NEXT


          19.CIRCUIT INSPECTION

            NEXT


            20.IDENTIFICATION OF PROBLEM

              NEXT


              21.REPAIR OR REPLACE

                NEXT


                22.CONFIRMATION TEST

                  NEXT

                  END