DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0711 | Either condition is met: 1. Conditions (a)*, (b), (c), (d), (e) and (f) are met (2-trip detection logic): (a) After the engine is stopped, 5 hours or more elapse before the engine is started. (b) 10 minutes elapse after the engine is started. (c) The vehicle is driven 4.7 km (3.0 miles) or more after the engine is started. (d) IAT is 15°C (59°F) or more. (e) ECT is 15°C (59°F) or more. (f) ATF temperature is less than 20°C (68°F). 2. Conditions (a) and (b) are met (2-trip detection logic): (a) Engine coolant temperature is less than 35°C (95°F) after the engine is started. (b) ATF temperature is 110°C (230°F) or more when the engine coolant temperature reaches 60°C (140°F) after 10 sec. or more. | Transmission wire (No. 1 ATF temperature sensor) |
| Related DTCs | P0711: ATF temperature sensor/Rationality check |
| Required sensors/Components | ATF temperature sensor |
| Frequency of operation | Continuous |
| Duration | 3 seconds |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | P0712, P0713, P2742, P2743 (ATF temperature sensor "A" circuit) P0327, P0328, P0332, P0333, P032C, P032D, P033C, P033D (IAT (Intake air temperature) sensor circuit) |
| ECT (Engine Coolant Temperature) sensor circuit | Not circuit malfunction |
| Soak time* | 5 hours or more |
| Duration time from engine start | 12 seconds or more |
| Time after engine start | 10 minutes |
| Driving distance after engine start | 4.7 km (3.0 miles) or more |
| IAT (12 seconds after engine start) | 15°C (59°F) or more |
| ECT (12 seconds after engine start) | 15°C (59°F) or more |
| Duration time for ECT to reach 60°C (140°F) | 10 seconds or more |
| ATF temperature (12 seconds after engine start) | 110°C (230°F) or more |
| ECT (12 seconds after engine start) | Less than 35°C (95°F) |
| ATF temperature | Less than 20°C (68°F) |
| ATF temperature | 110°C (230°F) or more |
| ATF temperature | 20°C (68°F) or more |
| ATF temperature | Less than 110°C (230°F) |
| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 1 | No. 1 ATF temperature sensor value/ Min.: -40°C (-40°F) Max.: 215°C (419°F) |
| If the value is -40°C (-40°F) or 215°C (419°F), the No. 1 ATF temperature sensor circuit is open or shorted. |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0711) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the Techstream.
| Result | Proceed to |
| Only P0711 is output | A |
| P0711 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
Check the transmission fluid level (Click here).
|
| ||||
| OK | ||
| ||