Remove the fuel pipe clamp.
Text in Illustration
*1
| Fuel Pipe Clamp
|
Disconnect the fuel tube.
Text in Illustration

| Pinch
|

| Pull
|
Connect SST to the fuel pipe (the vehicle side).
Text in Illustration
*1
| Hose
|
*2
| Clip
|
*3
| Fuel Tube Connector
|
*4
| Fuel Pipe
|
- SST
- 09268-31012
(09268-41500, 90467-13001, 95336-08070)
Install the O-ring to the fuel injector.
Text in Illustration
*1
| Clip
|
*2
| Adapter
|
*3
| Clamp
|
*4
| O-Ring
|
*5
| Tube
|
Install SST and the tube to the fuel injector.
- SST
- 09268-31012
(90467-13001, 09268-41300, 09268-41600)
Put the injector into a graduated cylinder.
Text in Illustration
*1
| Wire
|
- CAUTION:
- Install a strong rubber tube onto the injector to prevent gasoline from splashing.
Operate the fuel pump (turn the ignition switch to ON).
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
- SST
- 09842-30090
- Standard injection volume:
- 83 to 99 cm3 (5.0 to 6.0 cu in.) per 15 seconds
- Difference between each injector:
- 16 cm3 (1.0 cu in.) or less
If the injection volume is not as specified, replace the injector assembly.