Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the power tilt and power telescopic steering column system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Check for DTCs (Click here).
      Result 
      Result
      Proceed to
      CAN system DTC is not output
      A
      CAN system DTC is output
      B

      HINT:
      1. When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.



    B.
    Go to CAN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK FOR DTC*
    1. Check for DTCs (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck the DTCs (Click here).
      Result 
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccurs
      B



    B.
    Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    5.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B


    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List/Active Test (Click here)


    NEXT


    7.REPAIR

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END