Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > FAIL-SAFE CHART

for Preparation Click here


HINT:
If the power voltage to the tilt and telescopic ECU returns to normal within 10 seconds during tilt or telescopic operation, the operation will be resumed. If it returns to normal after 10 seconds have elapsed, the operation restarts when a tilt or telescopic operation signal is again input to the tilt and telescopic ECU.


Fail-Safe Operation  
DTC Code
Detection Item
Fail-safe
B2602
Key Unlock Warning Switch Circuit Malfunction
Auto away function stops.
Auto return function:
  1. Continues (when the ignition switch is ON).
  2. Stops (when the ignition switch is off).
B2603
Tilt and Telescopic Manual Switch Circuit Malfunction
Tilt and telescopic operation by manual switch is suspended.
B2610
Tilt Position Sensor or Tilt Motor Circuit Malfunction
Tilt operation is suspended.
B2611
Telescopic Position Sensor or Telescopic Motor Circuit Malfunction
Telescopic operation is suspended.
B2620
ECU Power Source Circuit Malfunction
Tilt and telescopic operation is suspended.
B2624
Speed Signal Malfunction
Auto away and/or auto return function stops.

FAIL-SAFE FUNCTION
  1. If a malfunction in the tilt position sensor signal or telescopic position sensor signal occurs while operating the power tilt or power telescopic function, the tilt and telescopic ECU stops the operation of the power tilt and power telescopic steering column system.

  2. If the power voltage to the ECU drops below approximately 8 V while operating the power tilt or power telescopic function, the ECU stops the operation of the power tilt and power telescopic steering column system.

  3. If the tilt and telescopic ECU detects that the motor has locked during the operation of the power tilt or power telescopic function, the ECU stops the operation of the power tilt and power telescopic steering column system.

  4. If the communication of an ECU that is related to the power tilt and power telescopic steering column system is interrupted, the system operates as shown below.


Function
Main Body ECU Communication Interruption
Outer Mirror Control ECU Communication Interruption
Front Power Seat Control Switch LH Communication Interruption
All ECUs*1 Communication Interruption
Manual
Disable*2
Normal
Normal
Disable*2
Automatic Away
Disable
Disable
Normal
Disable
Automatic Return
Disable*3
Disable*3
Normal
Disable*3
Memory
Disable
Disable
Disable
Disable
Recall
Disable*2
Disable
Disable
Disable

HINT:
  1. *1: All ECUs that are related to the power tilt and power telescopic steering column system.
  2. *2: The operation is permitted if the ignition switch signal is ON while the signal from the main body ECU is interrupted.
    The operation is prohibited if the ignition switch signal is off while the signal from the main body ECU is interrupted.
  3. *3: If the signal(s) from the ECU is/are interrupted after the operation has started, the operation will be continued when the ignition switch signal is ON, and prohibited when the ignition switch signal is off.