FUEL PUMP > INSTALLATION |
| 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
Apply a light coat of gasoline or grease to a new gasket, and install it to the fuel tank.
![]() |
Align the protrusion of the pump and gauge tube with the groove of the fuel tank.
Install the fuel suction with pump and gauge tube into the fuel tank.
Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer one complete turn by hand.
![]() |
Set SST on the retainer.
![]() |
Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank, as shown in the illustration.
![]() |
Install the 2 fuel tank tubes with the 2 tube joint clips.
![]() |
| 2. INSTALL FUEL TANK ASSEMBLY |
Install the fuel tank assembly (Click here).