Home › Engine / Hybrid System ยท 1UR-FE › FUEL › FUEL PUMP

FUEL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A152226
  1. Disconnect the fuel sender gauge connector.



    A152222E01
  1. Press down on the sender gauge claw labeled A. Then slide the sender gauge upward to remove it.



2. REMOVE SUB TANK


    A152227
  1. Disconnect the fuel pump connector.



    A152224
  1. Using a small screwdriver, detach the claw on the end of the tube from the claw hole. Disconnect the tube from the 2 clamps.



    A152228
  1. Disconnect the fuel tube.



    A152229
  1. Using a screwdriver, detach the 3 claws from the claw holes.

    HINT:
    Tape the screwdriver tip before use.



    A152230
  1. Using a screwdriver, detach the 2 claws from the claw holes and remove the sub tank.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the fuel sub tank.



3. REMOVE FUEL PUMP


    A152231
  1. Using a screwdriver, detach the 5 claws from the claw holes and disconnect the fuel pump from the suction plate with filter.

    HINT:
    Tape the screwdriver tip before use.



    A152232
  1. Remove the fuel pump harness.



    A152233E02
  1. Remove the O-ring and spacer from the fuel pump.