FUEL TANK > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Discharge the fuel system pressure (Click here).
| 2. REMOVE FUEL TANK CAP |
| 3. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Remove the bolt and disconnect the fuel pressure switching valve.
![]() |
Detach the lock claws by lifting up the cover, as shown in the illustration.
Pinch and pull the main tube connector to disconnect the fuel tank main tube sub-assembly connector from the pipe.
| 4. DISCONNECT FUEL TANK RETURN TUBE |
![]() |
Detach the lock claws by lifting up the cover, as shown in the illustration.
Pinch and pull the return tube connector to disconnect the fuel tank return tube connector from the pipe.
| 5. REMOVE FUEL TANK ASSEMBLY |
![]() |
Disconnect the fuel tank to filler pipe hose from the fuel tank assembly.
![]() |
Pull up the retainer and disconnect the vent line hose.
![]() |
Detach the lock claws by lifting up the cover, as shown in the illustration.
Disconnect the fuel tank breather tube from the fuel tank inlet pipe sub-assembly.
![]() |
Set a transmission jack underneath the fuel tank assembly.
Remove the 2 bolts, 2 clips, 2 pins and 2 fuel tank bands.
Slowly lower the transmission jack slightly.
![]() |
Disconnect the wire harness clamp from the fuel tank assembly.
Disconnect the fuel pump connector and fuel pressure switching valve connector, and then lower the transmission jack.
| 6. REMOVE FUEL TANK RETURN TUBE |
![]() |
Remove the tube joint clip and pull out the fuel tank return tube to remove it.
| 7. REMOVE NO. 1 FUEL TANK HEAT INSULATOR |
![]() |
Remove the nut from the heat insulator.
Using needle-nose pliers, remove the 4 clips shown in the illustration and No. 1 fuel tank heat insulator.
| 8. REMOVE FUEL PRESSURE SWITCHING VALVE ASSEMBLY |
![]() |
Remove the 2 tube joint clips and pull out the 2 fuel tank main tubes. Then remove the fuel pressure switching valve assembly.
| 9. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
![]() |
Set SST on the retainer.
![]() |
Using SST, loosen the retainer.
Remove the retainer.
Remove the fuel suction with pump and gauge tube assembly from the fuel tank.
Remove the gasket from the fuel tank.