Home › Engine / Hybrid System ยท CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    P1615    Communication Error from Distance Control ECU to ECM

for Preparation Click here


DESCRIPTION

The distance control ECU receives information about the area in front of the vehicle from the laser radar sensor and then sends a brake control demand signal (deceleration demand) and diagnosis signals, such as laser radar sensor grime signals or laser radar sensor malfunction signals, to the ECM.

DTC No.
DTC Detection Condition
Trouble Area
P1615
While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the distance control ECU is logically inconsistent for 0.5 seconds, the ECM records this logical error code
  1. Communication circuit
  2. Distance control ECU
  3. ECM

INSPECTION PROCEDURE

HINT:
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

NOTICE:
When the distance control ECU and ECM is replaced with a new one, initialization must be performed (Click here).

1.REPLACE DISTANCE CONTROL ECU
Replace the distance control ECU (Click here).

NEXT


2.PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    1. Turn the ignition switch to ON.

    2. Turn the cruise control main switch on.

    3. With the brake pedal depressed, push the cruise control main switch to + (ACCEL)/RES (RESUME) 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.

      NOTICE:
      1. Do not turn the light control switch on at this time because the beam axis automatic adjustment mode has already started, which could lead to incorrect beam axis. If the light control switch is turned on by mistake, readjust the beam axis (refer to Beam Axis Adjustment) (Click here).
      2. If initialization cannot be performed, first inspect the stop light switch circuit, cruise main switch circuit, and skid control buzzer circuit.


NEXT


3.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


4.CHECK FOR DTC
  1. Reproduce the DTC detection conditions under which the DTC is stored.

    HINT:
    If the DTC detection conditions are not correct, the system will not detect the trouble.

  1. Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for 3UR-FE)
    B
    DTC is output (for 3UR-FBE)
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

END (DISTANCE CONTROL ECU DEFECTIVE)